Nissan Sentra Service Manual: Engine
- Engine mechanical
- Precaution
- Preparation
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications (sds)
- Engine lubrication system
- Precaution
- Preparation
- System description
- Periodic maintenance
- Removal and installation
- Unit disassembly and assembly
- Service data and specifications (SDS)
- Engine cooling system
- Precaution
- Preparation
- System description
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (sds)
- Engine control system
- Precaution
- Preparation
- System description
- System
- Operation
- Ecu diagnosis information
- Wiring diagram
- Basic inspection
- Dtc/circuit diagnosis
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (SDS)
- Fuel system
- Precaution
- Preparation
- Periodic maintenance
- Removal and installation
- Disassembly and assembly
- Service data and specifications (SDS)
- Exhaust system
- Starting system
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
- Accelerator control system
Wiring diagram
Consult checking system
Wiring Diagram
...
Other materials:
Primary speed sensor
Exploded View
Transaxle assembly
O-ring
Primary speed sensor
: Always replace after every
disassembly.
: N m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the primary speed sensor connector.
Remove the primary speed sensor.
...
Making a call
To make a call from a phone connected to the
vehicle’s Bluetooth® Hands-Free Phone System:
NOTE:
Available commands different if system is
in Manual Control mode. See “Manual Control”
in this section for more information.
Press the button.
The system will prompt you for a command. ...
L terminal circuit (open)
Description
The “L” terminal circuit controls the charge warning lamp. The charge warning
lamp turns ON when the ignition
switch is set to ON or START. When the generator is providing sufficient voltage
with the engine running,
the charge warning lamp turns OFF. If the charge warnin ...
