Nissan Sentra Service Manual: Dtc/circuit diagnosis
- C1101, C1102, C1103, C1104 Wheel sensor
- C1105, C1106, C1107, C1108 Wheel sensor
- C1109 Power and ground system
- 1110, C1170 ABS Actuator and electric unit (control unit)
- C1111 PUMP MOTOR
- C1113, C1145, C1146 Yaw rate/side/decel G Sensor
- C1115 ABS Sensor [abnormal signal]
- C1116 Stop lamp switch
- C1120, C1122, C1124, C1126 ABS In valve system
- C1121, C1123, C1125, C1127 ABS OUT Valve system
- C1130 Engine signal
- C1140 Actuator relay system
- C1142 Press sensor
- C1143 Steering angle sensor
- 1144 Incomplete steering angle sensor adjustment
- C1155 BR Fluid level low
- C1164, C1165, C1166, C1167 CV/SV System
- U1000 CAN Comm circuit
- U1002 System comm (CAN)
- U1010 Control unit (CAN)
- Parking brake switch
- VDC OFF Switch
- ABS Warning lamp
- Brake warning lamp
- VDC OFF Indicator lamp
- Slip indicator lamp
Adjustment of steering angle sensor neutral position
Description
Refer to the table below to determine if adjustment of steering
angle sensor neutral position is required.
×: Required –: Not required
Work Procedure
ADJUSTMENT OF ST ...
C1101, C1102, C1103, C1104 Wheel sensor
Description
When the sensor rotor rotates, the magnetic field changes. It
converts the magnetic field changes to current
signals (rectangular wave) and transmits them to the ABS actuator and elec ...
Other materials:
Basic inspection
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.CHECK SYMPTOM
...
Diagnosis and repair work flow
Work flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW THE CUSTOMER FOR THE SYMPTOM
Interview the customer for the symptom (the condition and the environment
when the incident/malfunction
occurs).
>> GO TO 2.
2.CHECK SYMPTOM
Check the symptom from the customer information.
> ...
Excessive abs function operation
frequency
Diagnosis Procedure
1.CHECK START
Check front and rear brake force distribution using a brake
tester.
Is the inspection result normal?
YES >> GO TO 2
NO >> Check brake system.
2.CHECK FRONT AND REAR AXLE
Make sure that there is no excessive play in the front and rear
axles. ...
