Nissan Sentra Service Manual: C1113, C1145, C1146 Yaw rate/side/decel G Sensor

Nissan Sentra Service Manual / Brakes / Brake control system / Dtc/circuit diagnosis / C1113, C1145, C1146 Yaw rate/side/decel G Sensor

DTC Logic

DTC DETECTION LOGIC

DTC	Display Item	Malfunction detected condition	Possible causes
C1113	G SENSOR	When a malfunction is detected in longitunal G sensor signal.	ABS actuator and electric unit (control unit)
C1145	YAW RATE SENSOR	When a malfunction is detected in yaw rate signal. When yaw rate signal is not continuously received for 2 seconds or more. When side G signal is not continuously received for 2 seconds or more. When decel G signal is not continuously received for 2 seconds or more.
C1146	SIDE G-SEN CIRCUIT	When a malfunction is detected in side/decel G signal.

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT

Turn ignition switch OFF to ON.
Perform self diagnostic result.

Is DTC C1113, C1145 or C1146 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-67, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit).

>> Replace ABS actuator and electric unit (control unit). Refer to BRC-110, "Removal and Installation".

C1111 PUMP MOTOR

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1111 PUMP MOTOR When a malfunction is detected in motor or mot ...

C1115 ABS Sensor [abnormal signal]

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1115 ABS SENSOR [ABNORMAL SIGNAL] When difference in wheel speed betw ...

Other materials:

Normal operating condition
Compass Compass : description Compass The electronic compass is highly protected from changes in most magnetic fields. However, some large changes in magnetic fields can affect it. Some examples are (but not limited to): high tension power lines, large steel buildings, subways, steel ...

Power windows do not operate with power window main switch
Diagnosis Procedure 1.Check bcm power supply and ground circuit Check bcm power supply and ground circuit. Refer to bcs-67, "diagnosis procedure" (with intelligent key) or bcs-120, "diagnosis procedure" (without intelligent key). Is the inspection result normal? Yes & ...

Brake master cylinder
Inspection Check for brake fluid leakage at the following areas: Master cylinder mounting face Reservoir tank mounting face Brake tube and brake tube connections Brake hose and brake hose connections If any brake fluid leakage is found, repair as necessary. On Board Inspection LEAK ...