Nissan Sentra Service Manual: 1144 Incomplete steering angle sensor adjustment
DTC Logic
Dtc detection logic
| Dtc | Display item | Malfunction detected condition | Possible causes |
| C1144 | St ang sen signal | When neutral position adjustment of steering angle sensor is not complete. |
|
Dtc confirmation procedure
1.Check self diagnostic result
With consult
-
Turn ignition switch on.
-
Perform self diagnostic result.
Is dtc C1144 detected? Yes >> proceed to diagnosis procedure. Refer to brc-82, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.Adjust the neutral position of steering angle sensor
Perform neutral position adjustment of steering angle sensor. Refer to brc-54, "work procedure".
>> Go to 2.
2.Check self diagnostic result
With consult.
Perform self diagnostic result.
Is dtc c1144 detected? Yes >> go to 3.
No >> inspection end.
3.Check steering angle sensor system
Check steering angle sensor system. Refer to brc-80, "diagnosis procedure".
Is the inspection result normal? Yes >> replace abs actuator and electric unit (control unit). Refer to brc-110, "removal and installation".
No >> repair or replace malfunctioning components.
C1143 Steering angle sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1143
ST ANG SEN CIRCUIT
When a malfunction is detected in steering angl ...
C1155 BR Fluid level low
DTC Logic
Dtc detection logic
Dtc
Display item
Malfunction detected condition
Possible cause
C1155
C1155 br fluid level low
Brake fluid level is low or communication l ...
Other materials:
How to Check Terminal
CONNECTOR AND TERMINAL PIN KIT
Use the connector and terminal pin kits listed below when replacing
connectors or terminals.
The connector and terminal pin kits contain some of the most commonly
used NISSAN/INFINITI connectors
and terminals. For detailed connector and terminal pin repla ...
Ipdm-e branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ipdm e/r for damage, bend and
loose connection (unit side
and connector side).
Is the inspection result normal?
Yes ...
Tire labeling
Federal law requires tire manufacturers to
place standardized information on the
sidewall of all tires. This information identifies
and describes the fundamental
characteristics of the tire and also provides
the tire identification number (TIN)
for safety standard certification. The TIN
can b ...
