Nissan Sentra Service Manual: Without intelligent key system

Removal and installation

BCM Removal and installation Note: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-61, "CONFIGURATION (BCM) : Descr ...

Precaution

Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The supplemental restraint system such as “air bag” and “seat belt pre- ...

Other materials:

Rear window glass
Exploded View Rear window glass Spacer Rubber dam Body side outer Headlining Roof panel Trunk lid Adhesive 12 mm (0.5 in) 7 mm (0.3 in) 2.0 mm (0.08 in) 3 mm (0.1 in) Removal and Installation REMOVAL Partially remove the rear of the headlining (rear edge). R ...

Front disc brake
Exploded View Cap Bleeder valve Cylinder body Piston seal Piston Piston boot Upper sliding pin Lower sliding pin Sliding pin boot Bushing Torque member Apply brake fluid Apply rubber grease Disassembly and Assembly DISASSEMBLY Place a wooden block as shown, and ...

Operating tips
When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally. ...