Component Function Check
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started.
Is the inspection result normal? YES >> Inspection End.
NO >> Perform trouble diagnosis. Refer to STC-31, "Diagnosis Procedure".
Diagnosis Procedure
1.Perform self-diagnosis
With consult
Turn the ignition switch OFF to ON.
Perform EPS self-diagnosis.
Is any dtc detected? Yes >> check the dtc. Refer to stc-14, "dtc index".
No >> go to 2.
2.CHECK EPS WARNING LAMP SIGNAL
With consult
Turn the ignition switch on.
Caution:
Never start the engine.
Select DATA MONITOR of EPS and select WARNING LAMP.
Check that the EPS warning lamp is turned ON.
Start the engine.
CAUTION:
Never drive the vehicle.
Check that the EPS warning lamp is turned OFF.
Is the inspection result normal? YES >> Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-52, "COMBINATION METER : Diagnosis Procedure".
NO >> Replace EPS control unit. Refer to STC-39, "Removal and Installation".
U1000 CAN Comm circuitKey to Symbols Signifying Measurements or Procedures
...
B1430, B1432 Seat belt pre-tensioner LH
Description
DTC B1430, B1432 SEAT BELT PRE-TENSIONER LH
The seat belt pre-tensioner LH is wired to the air bag diagnosis sensor unit.
The air bag diagnosis sensor unit
will monitor for opens and shorts in detected lines to the seat belt pre-tensioner
LH.
PART LOCATION
Refer to SRC-5, " ...
Water outlet
Exploded View
CVT MODELS
Water control valve
Rubber ring
Radiator hose (upper)
Clamp
Water outlet
CVT oil warmer hose (outlet)
Heater hose (inlet)
Heater hose (outlet)
Electric throttle control actuator hose
(outlet)
Electric throttle control actuator hose
(inlet)
E ...