Nissan Sentra Service Manual: Rear power window switch
Removal and Installation
REMOVAL
- Release the pawls using a suitable tool and lift the rear power window switch and finisher as an assembly and remove
- Disconnect the harness connector from the rear power window switch.
- Release the pawl (one on each side) using a suitable tool, then separate the rear power window switch (1) from the rear power switch finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the power window and
door lock/unlock switch RH and finisher
as an assembly and remove.
Disconnect the har ...
Roof
...
Other materials:
Front door glass
Removal and Installation
REMOVAL
WARNING:
Before servicing, turn ignition switch OFF, disconnect both
battery terminals and wait at least three
minutes.
Do not use air tools or electric tools for servicing.
NOTE:
LH front door panel shown; RH side similar
Disconnect the battery ...
Wiring diagram
Ipdm e/r (intelligent power distribution module engine room)
Wiring diagram
...
Bluetooth® settings
To access and adjust the settings for the
Bluetooth® Hands-Free Phone System:
Press the SETTING button.
Use the TUNE/SCROLL knob to select
“Bluetooth” and then press the ENTER button:
Bluetooth
Select “On” or “Off” to turn the vehicle’s
Bluetooth® system on or ...
