Nissan Sentra Service Manual: Removal and installation

Rear disc brake

Brake Burnishing CAUTION: Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft ...

Brake pedal

Exploded View WITHOUT BRAKE PEDAL POSITION SWITCH Snap pin Brake pedal assembly Brake pedal pad Stop lamp switch Clip Clevis pin Apply multi-purpose grease. WITH BRAKE PEDAL POSI ...

Other materials:

Trunk room trim
Exploded View Trunk floor trim Trunk front floor spacer (LH) Trunk side finisher (LH) Reflector box assembly* Trunk rear plate Trunk side finisher (RH) Trunk front floor spacer (RH) Clip Pawl Trunk rear plate TRUNK REAR PLATE : Removal and Installation REMOVAL Remove ...

Can communication circuit
Diagnosis procedure 1.CONNECTOR INSPECTION Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect all the unit connectors on CAN communication system. Check terminals and connectors for damage, bend and loose connection. Is the inspection resu ...

P062F Eeprom
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P062F EEPROM (Internal Control Module EEPROM Error) Flash ROM error is detected when turning ON the ignition switch. TC ...