Nissan Sentra Service Manual: Push-button ignition switch illumination circuit
Description
Provides the power supply and the ground to control the push-button ignition switch illumination.
Component function check
1.Check push-button ignition switch illumination operation
Consult active test
- Turn the ignition switch ON.
- Select engine sw illumi of bcm (intelligent key) active test item.
- With operating the test items, check that the push-button ignition switch illumination turns ON/OFF.
On : push-button ignition switch illumination on
Off : push-button ignition switch illumination off
Does the push-button ignition switch illumination turn on/off? Yes >> push-button ignition switch illumination circuit is normal.
No >> refer to inl-49, "diagnosis procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to inl-26, "wiring diagram".
1.Check push-button ignition switch illumination power supply output
- Turn the ignition switch OFF
- Disconnect push-button ignition switch connector.
- Check voltage between push-button ignition switch harness connector and ground.
Is the inspection result normal? Yes >> go to 4.
No >> go to 2.
2.Check push-button ignition switch illumination power supply open circuit
- Disconnect bcm connector.
- Check continuity between bcm harness connector and the push-button ignition switch harness connector.
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check push-button ignition switch illumination power supply short circuit
Check continuity between bcm harness connector and ground.
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key), BCS-126, "Removal and Installation" (without Intelligent Key).
NO >> Repair or replace harness or connector.
4.Check push-button ignition switch illumination ground circuit
Check continuity between push-button ignition switch harness connector and ground.
Is the inspection result normal? Yes >> replace push-button ignition switch. Refer to sec-136, "removal and installation".
No >> repair or replace harness or connector.
Trunk room lamp circuit
Description
Controls the trunk room lamp (ground side) to turn the trunk room lamp on and
off.
Diagnosis Procedure
Regarding wiring diagram information, refer to inl-17, "wiring diagram" ...
Symptom diagnosis
Interior lighting system symptoms
Symptom Table
Caution:
Perform the self-diagnosis with consult before the symptom diagnosis.
Perform the trouble diagnosis
if any dtc is detected.
...
Other materials:
P1551, P1552 Battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P1551
BAT CURRENT SENSOR
(Battery current sensor)
An excessively low voltage from the sensor
is sent to ECM.
Harness or ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
Harness connector e4
Harness connec ...
Fuel-filler cap
WARNING
Gasoline is extremely flammable and
highly explosive under certain conditions.
You could be burned or seriously
injured if it is misused or mishandled.
Always stop the engine and do not
smoke or allow open flames or sparks
near the vehicle when refuelin ...
