Nissan Sentra manuals

Nissan Sentra Service Manual: Symptom diagnosis

Nissan Sentra Service Manual / Cruise control & driver assistance / Drive mode system / Eco mode (cvt) / Symptom diagnosis

The eco mode indicator lamp does not turn on

Description

The ECO mode indicator lamp does not turn ON when the ECO mode switch is operated.

Diagnosis Procedure

1.Perform combination meter on board diagnosis

Perform combination meter on board diagnosis. Refer to MWI-16, "Description".

Is the check result normal? YES >> GO TO 2.

NO >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

2.Check dtc (tcm)

With consultv


  1. Start the engine.
  2. Check “self diagnostic results” in “transmission”.

Is any DTC detected? YES >> Check DTC detected item. Refer to TM-126, "DTC Index".

NO >> GO TO 3.

3.Check dtc (ecm)

Check “self diagnostic results” in “engine”. With consult


Check “self diagnostic results” in “engine”.

Is any dtc detected? Yes >> check dtc detected item. Refer to ec-94, "dtc index".

No >> go to 4.

4.Check dtc (combination meter)

Check “self diagnostic results” in “meter/m&a”. With consult


Check “self diagnostic results” in “meter/m&a”.

Is any dtc detected? Yes >> check dtc detected item. Refer to mwi-26, "dtc index".

No >> go to 5.

5.Check combination meter input/output signal

  With consult


  1. Select “data monitor” in “meter/m&a”.
  2. Select “eco mode ind”.
  3. Check that “ECO MODE IND” turns ON/OFF when ECO mode switch is operated. Refer to MWI-20, "Reference Value".

Is any DTC detected? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> GO TO 6.

6.Check eco mode switch circuit

Check eco mode switch circuit. Refer to dms-34, "diagnosis procedure".

Is any dtc detected? Yes >> inspection end

No >> repair or replace malfunctioning parts.

Dtc/circuit diagnosis
Eco mode switch Component function check 1. Check eco mode switch operation Turn ignition switch ON. Check ECO mode indicator lamp turns ON/OFF on combination meter when turn ECO mode swit ...

Removal and installation
Eco mode switch Removal and installation Removal Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation". Remove ECO mode switch. Installation Installatio ...

Other materials:

Handling precautions for plastics
Precautions for plastics When repairing and painting a portion of the body adjacent to plastic parts, consider their characteristics (influence of heat and solvent) and remove them if necessary or take suitable measures to protect them. Plastic parts should be repaired and painted ...

Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment. Observe the following precautions when disassembling. Before disassembly, thoroughly clean the outside of the unit. ...

Vehicle loading information
WARNING It is extremely dangerous to ride in a cargo area inside a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. Do not allow people to ride in any area of your vehicle that is not equipped with seats a ...

© 2014-2026 Copyright b17.nisentra.com