Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Eco mode switch

Removal and installation

Removal

  1. Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
  2. Remove ECO mode switch.

Installation

Installation is in the reverse order of removal.

Symptom diagnosis
The eco mode indicator lamp does not turn on Description The ECO mode indicator lamp does not turn ON when the ECO mode switch is operated. Diagnosis Procedure 1.Perform combination meter on boa ...

Sport mode (m/t)
...

Other materials:

L terminal circuit (open)
Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp turns ON when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp turns OFF. If the charge warnin ...

Air cleaner and air duct
Exploded View Mass air flow sensor Mass air flow gasket Clamp Air duct (suction side) Resonator Clamp PCV hose Clamp Clamp Air cleaner cover Mounting rubber Air cleaner filter Air cleaner body Air duct inlet (lower) Air duct inlet (upper) Mounting rubber Brack ...

Component parts
STARTING SYSTEM (WITH INTELLIGENT KEY) Component Parts Location Starter motor Transmission range switch (CVT Models) IPDM E/R (view with air inlet duct removed) Clutch interlock switch (M/T Models) ECM BCM (view under instrument panel, left side of vehicle) Component Descri ...

© 2014-2026 Copyright b17.nisentra.com