Nissan Sentra manuals

Nissan Sentra Service Manual: Power window and door lock/unlock switch RH

Removal and Installation

REMOVAL

  1. Release the pawls using a suitable tool and lift the power window and door lock/unlock switch RH and finisher as an assembly and remove.
  2. Disconnect the harness connector from the power window and door lock/unlock switch RH.
  3. Release the four pawls (two on each side) using a suitable tool, then separate the main power window and door lock/unlock switch RH (1) from the main power window and door lock switch RH finisher (2).

CAUTION: : Pawl


CAUTION:

Do not bend back the pawls on the switch finisher too far or breakage may occur.

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Main power window and door lock/ unlock switch
Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the main power window and door lock/unlock switch and finisher as an assembly and remove. Disconnect the h ...

Rear power window switch
Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the rear power window switch and finisher as an assembly and remove Disconnect the harness connector from ...

Other materials:

ECU diagnosis information
TCM Reference Value CONSULT DATA MONITOR STANDARD VALUE NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. In CONSULT, electric shift timing or lock-up timing, i.e. op ...

P0130 A/F Sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control. DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possi ...

Service data and specifications (SDS)
Wheel Alignment (Unladen*1) UNITED STATES and CANADA *1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools, and mats are in designated positions. *2: The difference when assuming the (LH) side is the standard. Ball Joint Wheelarch Height (Unladen*) UNITED S ...

В© 2014-2026 Copyright b17.nisentra.com