Nissan Sentra Service Manual: The seat belt reminder warning continues sounding, or does not sound
Description
- Seat belt reminder warning does not sound.
- Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
- Turn ignition switch on.
- Check the operation of the seat belt warning lamp in the combination meter.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch (lh) signal circuit
Check the seat belt buckle switch (lh) circuit. Refer to wcs-29, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch (lh)
Check the seat belt buckle switch (LH). Refer to WCS-30, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Replace seat belt buckle (LH). Refer to SR-32, "Removal and Installation".
The parking brake release warning
continues sounding, or does not
sound
Description
The parking brake warning buzzer sounds continuously during vehicle
travel though the parking brake is
released.
The parking brake warning buzzer does not sound at all even tho ...
The light reminder warning does
not sound
Description
Light reminder warning chime does not sound even though headlamp is
illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&am ...
Other materials:
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other me ...
P1652 Starter motor system comm
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
The steering switch (meter control switch) is inoperative
Description
If any of the following malfunctions is found for the steering switch (meter
control switch) operation.
All switches are inoperative
The specified switch cannot be operated
Diagnosis procedure
1.Check steering switch signal circuit
Check the steering switch signal circuit. ...
