Nissan Sentra Service Manual: B2205 vehicle speed

Nissan Sentra Service Manual / Driver information & multimedia / Meter, warning lamp & indicator / Dtc/circuit diagnosis / B2205 vehicle speed

Description

The abs actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via can communication lines.

DTC Logic

Dtc detection logic

Dtc	Consult	Detection condition	Possible malfunction location
B2205	VEHICLE SPEED CIRC [B2205]	Malfunction is detected when an erroneous speed signal is received for 2 seconds or more.	Combination meter Abs actuator and electric unit (control unit)

Diagnosis Procedure

1.Check combination meter input signal

Start engine and select METER/M&A on CONSULT.
Using SPEED METER on DATA MONITOR, compare the value of DATA MONITOR with speedometer pointer of combination meter. Speedometer and DATA MONITOR indications should be close.

Is the inspection result normal? Yes >> perform abs actuator and electric unit (control unit) self-diagnosis. Refer to brc-31, "consult function (abs)".

No >> replace combination meter. Refer to mwi-77, "removal and installation".

U1010 control unit (can)

Description Initial diagnosis of combination meter. Dtc logic Dtc detection logic Dtc Display contents of consult Detection condition Possible malfunction U1010 CONTRO ...

B2267 engine speed

Description The engine speed signal is transmitted from ecm to the combination meter via can communication. Dtc logic Dtc detection logic Dtc Consult Detection condition Possible ...

Other materials:

Using the system
The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. Initialization When the ignition switch is placed in the ON position, NISSAN ...

ECO mode switch
ECO mode switch The ECO mode helps to enhance the fuel economy by controlling the throttle sensitivity and transmission points (CVT if so equipped). To turn on the ECO mode, push the ECO mode switch. The ECO mode indicator light (on the speedometer) will remain lit while the mode is act ...

L terminal circuit (open)
Description The вЂњLвЂќ terminal circuit controls the charge warning lamp. The charge warning lamp turns ON when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp turns OFF. If the charge warnin ...