Nissan Sentra Service Manual: The parking brake release warning continues sounding, or does not sound
Description
- The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released.
- The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied.
Diagnosis procedure
1.Check parking brake warning lamp
- Start the engine.
- Check the operation of the brake warning lamp by operating the parking brake.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check parking brake switch signal circuit
Check the parking brake switch signal circuit. Refer to mwi-60, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check parking brake switch
Check the parking brake switch. Refer to mwi-61, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> replace parking brake switch. Refer to pb-7, "exploded view".
Warning chime system symptoms
Symptom table
Caution:
Perform the self-diagnosis with consult before the symptom diagnosis.
Perform the trouble diagnosis
if any dtc is detected.
...
The seat belt reminder warning
continues sounding, or does not
sound
Description
Seat belt reminder warning does not sound.
Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
Turn ignition switch on.
Chec ...
Other materials:
Front wiper motor ground circuit
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With
Intelligent Key" or WW-29,
"Wiring Diagram - Without Intelligent Key".
1.Check front wiper motor (gnd) open circuit
Turn the ignition switch OFF.
Disconnect front wiper mot ...
U1010 Control unit (CAN)
Description
Initial diagnosis of ABS actuator and electric unit (control
unit)
DTC Logic
DTC DETECTION LOGIC
DTC
Items
(CONSULT screen terms)
DTC detection condition
Possible cause
U1010
CONTROL UNIT (CAN)
When detecting error during the initial diagnosis
...
Dtc/circuit diagnosis
U1000 can comm
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual can diagnostic symptoms and ...
