Nissan Sentra Service Manual: The light reminder warning does not sound
Description
Light reminder warning chime does not sound even though headlamp is illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&a and check the buzzer monitor value.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check front door switch lh signal circuit
Check the front door switch lh signal circuit. Refer to dlk-102, "diagnosis procedure" (with intelligent key system) or dlk-253, "diagnosis procedure" (without intelligent key system).
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check front door switch lh
Check front door switch lh. Refer to dlk-103, "component inspection" (with intelligent key system) or dlk- 255, "component inspection" (without intelligent key system).
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> replace the front door switch lh. Refer to dlk-194, "removal and installation" (with intelligent key system) or dlk-341, "removal and installation" (without intelligent key system).
The seat belt reminder warning
continues sounding, or does not
sound
Description
Seat belt reminder warning does not sound.
Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
Turn ignition switch on.
Chec ...
The key warning does not sound
(without intelligent key)
Description
The key warning chime does not sound, when all of the following conditions
are fulfilled.
Key inserted into the key cylinder (key switch signal on).
Ignition switch is in acc or o ...
Other materials:
U1000 Can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real-time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, an ...
P1650 Starter motor relay 2
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt
pre-tensioner"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injur ...
