Nissan Sentra Service Manual: Steering column
Inspection
STEERING COLUMN ASSEMBLY
-
Check each part of steering column assembly for damage or other malfunctions. Replace entire steering column assembly if any parts are damaged.
-
Measure steering column rotating torque using Tool. Replace steering column assembly if outside the specification.
Tool number (A) : ST3127S000 (J-25765-A)
Rotating torque : Refer to ST-18, "Steering Column".
-
Measure the length (L) as shown if vehicle has been involved in a minor collision. Replace steering column assembly if outside the specifications.
Steering column length (L) : Refer to ST-18, "Steering Column".
-
Check each part of steering column assembly for damage or other malfunctions. Replace if there are any abnormal conditions.
-
Check the steering wheel play, neutral position steering wheel, steering wheel turning force, and front wheel turning angle.Refer to ST-5, "Inspection"
-
Check tilt mechanism operating range and telescopic mechanism operating range as shown.
Tilt mechanism operating range (A) : Refer to ST-18, "Steering Column".
Telescopic mechanism operating range (B) : Refer to ST-18, "Steering Column".
Steering wheel
Inspection
CONDITION OF INSTALLATION
Check installation condition of power steering gear
assembly, front suspension, front drive shaft and steering
column.
Check if movement exists w ...
Steering gear and linkage
Inspection
INSPECTION AFTER DISASSEMBLY
BOOT
Check boot for cracks. Replace if any damage is found.
STEERING GEAR ASSEMBLY HOUSING
Check steering gear assembly housing for damage ...
Other materials:
Dome light
The interior light has a three-position switch and
operates regardless of ignition switch position.
When the switch is in the ON position 1 , the
interior lights illuminate, regardless of door position.
The lights will go off after a period of time
unless the ignition switch is placed in ...
P0327, P0328 KS
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0327
KNOCK SEN/CIRC-B1
(Knock sensor 1 circuit
low bank 1)
An excessively low voltage from the knock sensor
is sent to ECM.
...
Center console assembly
Exploded View
Center console upper finisher
Center console side finisher (RH)
Center console side finisher (LH)
Center console side finisher screw cover (LH/
RH)
Center console assembly
Center console screw cover (LH/
RH)
Center console rear finisher
Center console rear fi ...
