Nissan Sentra Service Manual: Steering gear and linkage
Inspection
INSPECTION AFTER DISASSEMBLY
BOOT
-
Check boot for cracks. Replace if any damage is found.
STEERING GEAR ASSEMBLY HOUSING
-
Check steering gear assembly housing for damage and scratches. Replace if there are any abnormal conditions.
OUTER SOCKET AND INNER SOCKET
Ball joint swinging torque
-
Hook a spring balance to the ball stud and inner socket measuring point (*) and pull the spring balance. Make sure that the spring balance reads the specified value when ball stud and inner socket start to move. Replace outer socket and inner socket if they are outside the specification.
Tool number : — (J-44372)
Swinging torque : Refer to ST-19, "Power Steering Gear".
Ball joint rotating torque
-
Make sure that the reading is within the following specified range using Tool. Replace outer socket if the reading is outside the specification.
Tool number (A) : ST3127S000 (J-25765-A)
Rotating torque : Refer to ST-19, "Power Steering Gear".
INSPECTION AFTER INSTALLATION
-
Check if steering wheel turns smoothly when it is turned several times fully to the end of the left and right.
-
Check the steering wheel play, neutral position steering wheel, steering wheel turning force, and front wheel turning angle.
-
Steering wheel play: Refer to ST-5, "Inspection".
-
Neutral position steering wheel, steering wheel turning force, and front wheel turning angle: Refer to ST-5, "Inspection".
Steering column
Inspection
STEERING COLUMN ASSEMBLY
Check each part of steering column assembly for damage or
other malfunctions. Replace entire steering column
assembly if any parts are damaged.
Me ...
Symptom diagnosis
Noise, vibration and harshness (NVH) troubleshooting
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If
necessary, repair or replace these parts.
×: Appl ...
Other materials:
Engine control system
Symptom Table
SYSTEM — BASIC ENGINE CONTROL SYSTEM
1 - 6: The numbers refer to the order of inspection.
(continued on next table)
SYSTEM — ENGINE MECHANICAL & OTHER
1 - 6: The numbers refer to the order of inspection. ...
Unbalance steering wheel turning force (torque variation)
Description
Unbalance steering wheel turning force (torque variation).
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
Turn the ignition switch OFF to ON.
Perform EPS self-diagnosis.
Is any DTC detected?
YES >> Check the DTC. Refer to STC-14, "DTC Index&quo ...
Chassis and body maintenance
In-cabin microfilter
In-cabin microfilter : removal and installation
REMOVAL
Remove the in-cabin microfilter cover.
CAUTION:
Before removing the in-cabin microfilter cover, let the vehicle rest
for at least 30 minutes.
Release the filter cover tab (A), then pull the bottom of the in- ...
