Nissan Sentra Service Manual: Periodic maintenance

Rear disc brake

BRAKE PAD BRAKE PAD : Inspection PAD WEAR Check pad thickness from an inspection hole on caliper body. Check using a scale if necessary. Wear limit thickness : Refer to BR-55, "Rear Disc Br ...

Brake pedal

Adjustment BRAKE PEDAL HEIGHT Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation". Disconnect the harness connectors from the brake pedal position switch ...

Other materials:

P1652 Starter motor system comm
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

Garage Jack and Safety Stand and 2-Pole Lift
WARNING: Park the vehicle on a level surface when using the jack. Make sure to avoid damaging pipes, tubes, etc. under the vehicle. Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle. Place wheel chock ...

Eco mode control
ECO MODE CONTROL : System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION ECM receives an ECO mode signal from combination meter via CAN communication and improves the fuel economy by controlling the throttle movement to less than usual. Therefore, driving characteristic is controlle ...