Nissan Sentra Service Manual: Front wiper arm
Exploded View
- Wiper blade (RH)
- Wiper arm (RH)
- Wiper drive assembly
- Wiper arm (LH)
- Wiper blade (LH)
Removal and Installation
REMOVAL
- Remove the wiper arm cap.
- Remove the wiper arm nut.
- Raise the wiper arm, then remove the wiper arm.
INSTALLATION
- Clean the wiper arm mount as shown.
NOTE:
This will reduce the possibility of wiper arm looseness.
- Install the wiper arm.
- Install the wiper arm nut.
- Install the wiper arm cap.
- Check that the wiper blades stop at the park position.
Washer nozzle & tube
Exploded view
Check valve
Washer tube
Washer tank
Washer pump
Washer nozzle
Clip
Washer nozzle
Washer nozzle : removal and installation
REMOVAL
Disconnect the washer nozzle ...
Wiper blade
Wiper blade
WIPER BLADE : Removal and Installation
REMOVAL
Put the wiper arms in the service position.
Turn the ignition switch ON and then OFF.
Within 1 minute, activate washer switch 2 ...
Other materials:
B142A Ignition voltage
Description
DTC B142A IGNITION VOLTAGE
Ignition voltage is supplied to the air bag diagnosis sensor unit when the
ignition is in the ON position. The air
bag diagnosis sensor unit will monitor for low or high ignition voltage.
PART LOCATION
Refer to SRC-5, "Component Parts Location" ...
EPS branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the EPS control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
Fuel pump
Component Function Check
1.CHECK FUEL PUMP FUNCTION
Turn ignition switch ON.
Pinch fuel feed hose with
two fingers.
Fuel pressure pulsation should be felt on the fuel feed
hose for 1 second after ignition switch is turned ON.
Is the inspection result normal?
YES >> INSPECT ...
