Nissan Sentra Service Manual: A/c auto amp. Connection recognition signal circuit
Description
A/c auto amp. Transmits the a/c auto amp. Connection recognition signal to the combination meter
Diagnosis procedure (with manual a/c)
Regarding wiring diagram information, refer to mwi-28, "wiring diagram".
1.Check a/c auto amp. Connection recognition signal
- Turn ignition switch on.
- Check voltage between combination meter harness connector and ground.
Is the inspection result normal? Yes >> inspection end.
No >> go to 2.
2.Check a/c auto amp. Connection recognition signal circuit
- Turn ignition switch OFF.
- Disconnect combination meter connector and a/c auto amp. Connector.
- Check continuity between combination meter harness connector and a/c auto amp. Harness connector.
- Check continuity between combination meter harness connector and ground.
Is the inspection result normal? Yes >> inspection end.
No >> repair or replace harness or connector.
Ambient sensor signal circuit
Description
It detects outside air temperature and converts it into a resistance value
which is then input into the combination
meter.
Diagnosis Procedure
Regarding wiring diagram information, ...
Washer fluid level switch circuit
Description
Transmits the washer level switch signal to the combination meter.
Diagnosis procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check wash ...
Other materials:
P0453 EVAP Control system pressure sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0453
EVAP SYS PRES SEN
(Evaporative emission system
pressure sensor/switch high)
An excessively high voltage from the
sensor is ...
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Control buttons
The control buttons for the Bluetooth® Hands-Free
Phone System are located on the steering wheel.
PHONE/SEND
Press the button to
initiate a
VR session or answer an incoming
call.
You can also use the button to
interrupt the system feedback and
give a command at once. See “L ...
