Nissan Sentra Service Manual: Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or damage to the components may occur.
Note:
The vanity mirror lamp is replaced as part of the sun visor. Refer to int-40, "removal and installation".
Bulb or lens replacement
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
- Do not attempt to separate the vanity mirror lamp from the sun visor or damage to the components may occur.
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Release the pawls on the vanity mirror lamp lens (1) using a suitable tool.
Pawl
- Remove the bulb (a) using a suitable tool.
- Install bulb to vanity mirror lamp.
- Install the vanity mirror lamp lens.
Map lamp
Removal and installation
Removal
Lower front edge of map lamp (1) down from the headlining by
releasing the metal clips, then slide forward to clear pawls at
rear.
: Metal clip
Pawl
D ...
Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Other materials:
Encoder
Driver side
DRIVER SIDE : Description
Detects condition of the front power window motor lh operation and transmits
to main power window and door
lock/unlock switch as pulse signal.
DRIVER SIDE : Component Function Check
1. Check encoder operation
Check front door glass lh perform auto open ...
U1010 Control unit (CAN)
Description
Initial diagnosis of ABS actuator and electric unit (control
unit)
DTC Logic
DTC DETECTION LOGIC
DTC
Items
(CONSULT screen terms)
DTC detection condition
Possible cause
U1010
CONTROL UNIT (CAN)
When detecting error during the initial diagnosis
...
System
Body control system
Body control system : system description
OUTLINE
BCM (Body Control Module) controls the various electrical components. It
inputs the information required to
the control from CAN communication and the signal received from each switch
and sensor.
BCM has combination ...
