Nissan Sentra Service Manual: Map lamp
Removal and installation
Removal
Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear.
: Metal clip
Pawl
- Disconnect the harness connectors from the map lamp and remove.
Installation
Installation is in the reverse order of removal.
Bulb replacement
The map lamp led bulbs are replaced as part of the map lamp. Refer to inl-52, "removal and installation".
Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or
damage to the components
may occur.
Note:
The vanity mirror lamp is replaced as part o ...
Other materials:
Seat belts
The seat belts can be cleaned by wiping them
with a sponge dampened in a mild soap solution.
Allow the belts to dry completely in the shade
before using them. See “Seat belt maintenance”
in the “Safety – Seats, seat belts and supplemental
restraint system” section of this manual.
...
C1115 ABS Sensor [abnormal signal]
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1115
ABS SENSOR
[ABNORMAL SIGNAL]
When difference in wheel speed between any wheel
and others is detected while the vehicle is driven, because
of installation of t ...
Can communication
CAN COMMUNICATION : System Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped ...
