Nissan Sentra Service Manual: Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
Removal
- Remove the glove box assembly. Refer to ip-22, "removal and installation".
- Rotate the glove box lamp socket assembly counterclockwise and remove.
- Remove the glove box lamp housing.
Installation
- Install the glove box lamp housing.
- Insert bulb socket into glove box lamp housing and rotate clockwise to lock in position.
- Install glove box assembly. Refer to ip-22, "removal and installation".
Bulb replacement
The glove box lamp bulb is serviced as part of the glove box lamp socket. Refer to inl-54, "removal and installation".
Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or
damage to the components
may occur.
Note:
The vanity mirror lamp is replaced as part o ...
Interior room lamp
Removal and installation
Removal
Insert a suitable tool into the gap between the headlining and the
interior room lamp and release the interior
room lamp.
Disconnect the harness connector ...
Other materials:
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to lan-7, "can communication system : system description".
DTC Logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual can diagnostic sym ...
Fuel level sensor unit, fuel filter and fuel pump assembly
Exploded View
Lock ring
Fuel level sensor, fuel filter and fuel
pump assembly
O-ring
Fuel tank
Removal and Installation
WARNING:
Read “General Precautions” when working on the fuel system. Refer to
FL-2, "General Precaution".
NOTE:
When removing componen ...
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on can communication system.
Check terminals and connectors for damage, bend and loose connection.
Is the inspection resu ...
