Nissan Sentra Service Manual: Parking brake switch signal circuit
Component function check
1.Check parking brake switch operation
Check that brake warning lamp in combination meter turns on/off when parking brake is actuated.
Is the inspection result normal? Yes >> inspection end.
No >> proceed to diagnosis procedure. Refer to mwi-60, "diagnosis procedure".
Diagnosis procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Connector inspection
- Turn ignition switch off.
- Disconnect combination meter and parking brake switch connectors.
- Check connectors and terminals for deformation, disconnection, looseness or damage.
Is the inspection result normal? Yes >> go to 2 no >> repair or replace as necessary.
2.Check parking brake switch
Check parking brake switch. Refer to mwi-61, "component inspection".
Is the inspection result normal? Yes >> go to 3.
No >> replace parking brake switch. Refer to pb-7, "exploded view".
3.Check parking brake switch signal
With consult
- Connect combination meter connector and parking brake switch connectors.
- Turn ignition switch on.
- In “DATA MONITOR” select “PARK BRAKE SW” and check parking brake switch signal.
Is the inspection result normal? Yes >> refer to mwi-45, "work flow".
No >> go to 4.
4.Check parking brake switch circuit
- Turn ignition switch off.
- Disconnect combination meter and parking brake switch connectors.
- Check continuity between combination meter connector M24 terminal 10 and parking brake switch connector M130 terminal 1.
- Check continuity between combination meter connector and ground.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> repair or replace malfunctioning components.
Component inspection
1.Check parking brake switch
- Turn ignition switch off.
- Disconnect parking brake switch connector.
- Check continuity between parking brake switch terminal 1 and ground.
Is the inspection result normal? Yes >> inspection end.
No >> replace parking brake switch. Refer to pb-7, "exploded view".
Fuel level sensor signal circuit
Description
The fuel level sensor unit and fuel pump detects the approximate fuel level
in the fuel tank and transmits the
fuel level signal to the combination meter.
Component function check
1 ...
Ambient sensor signal circuit
Description
It detects outside air temperature and converts it into a resistance value
which is then input into the combination
meter.
Diagnosis Procedure
Regarding wiring diagram information, ...
Other materials:
U1010 Control unit (CAN)
Description
Initial diagnosis of ABS actuator and electric unit (control
unit)
DTC Logic
DTC DETECTION LOGIC
DTC
Items
(CONSULT screen terms)
DTC detection condition
Possible cause
U1010
CONTROL UNIT (CAN)
When detecting error during the initial diagnosis
...
Front combination lamp
Exploded View
Large cover (not serviceable)
Small cover (not serviceable)
Front combination lamp
Halogen lamp bulb (high beam)
Turn signal lamp bulb
Turn signal lamp bulb socket
LED harness connector
Halogen lamp bulb (high beam)
harness connector
Halogen lamp bulb (low bea ...
Symptom diagnosis
Power door lock system symptoms
Symptom table
Door lock/unlock function malfunction
Note:
Before performing the diagnosis in the following table, check “WORK
FLOW”. Refer to DLK-245, "Work
Flow".
Check that vehicle is under the condition shown in “conditions of ...
