Nissan Sentra Service Manual: P0460 Fuel level sensor

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P0460 Fuel level sensor

DTC Logic

DTC DETECTION LOGIC

NOTE:

If DTC P0460 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
If DTC P0460 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-350, "DTC Logic".

When the vehicle is parked, naturally the fuel level in the fuel tank is stable. It means that output signal of the fuel level sensor does not change. If ECM senses sloshing signal from the sensor, fuel level sensor malfunction is detected.

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition	Possible cause
P0460	FUEL LEV SEN SLOSH (Fuel Level Sensor ″A″ Circuit)	Even though the vehicle is parked, a signal being varied is sent from the fuel level sensor to ECM.	Harness or connectors (The CAN communication line is open or shorted) Harness or connectors (The sensor circuit is open or shorted) Combination meter Fuel level sensor

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start engine and wait maximum of 2 consecutive minutes.
Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-326, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK COMBINATION METER FUNCTION

Refer to MWI-17, "CONSULT Function (METER/M&A)".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".

NO >> Refer to MWI-58, "Diagnosis Procedure".

P0456 EVAP Control system

DTC Logic DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease ...

P0461 Fuel level sensor

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0461 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P0461 is displayed with DTC P0607, first perform the ...

Other materials:

Service Notice and Precautions for EPS System
Check the following item when performing the trouble diagnosis. Check any possible causes by interviewing the symptom and it′s condition from the customer if any malfunction, such as EPS warning lamp is turned ON, occurs. Check if air pressure and size of tires are proper, t ...

System
Headlamp system HEADLAMP SYSTEM : System Diagram HEADLAMP SYSTEM : System Description LOW BEAM OPERATION When the lighting switch is in 2nd position, the BCM receives input requesting the headlamps to illuminate. This input is communicated to the IPDM E/R across the CAN communication l ...

Removal and installation
EPS control unit Exploded View Steering column assembly EPS control unit Bracket plate Front Removal and Installation REMOVAL CAUTION: Disconnect battery negative terminal before starting operations. Do not shock EPS control unit, e.g. drop or hit. Do not ...