Nissan Sentra Service Manual: Optical sensor
Removal and installation
REMOVAL
- Remove the defroster grille (LH) using a suitable tool.
- Disconnect the harness connector from the optical sensor.
- Release the pawls and remove the optical sensor.
INSTALLATION
Installation is in the reverse order of removal.
Hazard switch
Removal and Installation
REMOVAL
Remove cluster lid C (1). Refer to IP-20, "Removal and Installation
- Cluster Lid C".
Release pawls at ( ) and remove hazard switch (2).
INST ...
Other materials:
P0420 Three way catalyst function
DTC Logic
DTC DETECTION LOGIC
The ECM monitors the switching frequency ratio of air fuel ratio (A/F)
sensor 1 and heated oxygen sensor 2.
A three way catalyst (manifold) with high oxygen storage capacity
will indicate a low switching frequency of heated oxygen sensor 2.
As oxygen storage c ...
Recommended fluids and lubricants
Fluids and lubricants
*1: For additional information, see “engine oil recommendation”.
*2: As an alternative to this recommended oil, sae 5w-30 conventional
petroleum based oil may be used and meet all specifications
and requirements necessary to maintain the new vehicle limited ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT PRE-TENSIONER"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”,
used along
with a front seat belt, helps to reduce the risk or severity of injur ...
