Nissan Sentra Owners Manual: Manual control

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Bluetooth® Hands-Free Phone System without Navigation System (Type A) (if so equipped) / Manual control

While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise of driving makes it difficult for the voice recognition system to accurately interpret commands.

The manual control mode does not allow dialing a phone number by digits. The user may select an entry from the Phonebook or Recent Calls lists. To re-activate voice recognition, exit the manual control mode by pressing and holding the PHONE/END ( time, ) button. At that
time, pressing the PHONE/SEND ( will ) button
will start the Hands Free Phone System.

Operating tips

To enter manual control mode, start the voice recognition system and tilt the tuning ( ) switch up or down. The
system will speak Showing Manual Options when manual controls are initially activated.
To browse the menu options, tilt the tuning ( ) switch up or down. The
system will always speak the current menu option. Depending on the audio display, it will also show the current menu option.
To select the current menu option, press the PHONE/SEND ( ) button.

To go back to the previous menu, press the PHONE/END ( ) button. If the
current menu is the Main Menu, pressing the PHONE/END ( ) button will exit
the Phone system.
To exit the manual control mode, press and hold the PHONE/END ( ) button
for 5 seconds

Voice Adaptation (VA) mode

Voice Adaptation allows up to two out-of-dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice ...

Troubleshooting guide

The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solutio ...

Other materials:

B0091 Front side air bag satellite sensor LH
Description DTC B0091 FRONT SATELLITE SENSOR LH The front side air bag satellite sensor LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the front side air bag satellite sensor LH for internal failures and its circuits for communication errors. ...

Forward-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a forward-facing child restraint using the LATCH system: Position the child restraint on the seat. Always follow the child r ...

DTC/circuit diagnosis
U1000 can comm Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms a ...