Nissan Sentra Owners Manual: Troubleshooting guide

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Bluetooth® Hands-Free Phone System without Navigation System (Type A) (if so equipped) / Troubleshooting guide

The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions.

Where the solutions are listed by number, try each solution in turn, starting with number 1, until the problem is resolved.

Symptom	Solution
System fails to interpret the command correctly.	Ensure that the command is valid. See “List of voice commands” in this section. Ensure that the command is spoken after the tone. Speak clearly without pausing between words and at a level appropriate to the ambient noise level in the vehicle. Ensure that the ambient noise level is not excessive (for example, windows open or defroster on). NOTE: If it is too noisy to use the phone, it is likely that the voice commands will not be recognized. If more than one command was said at a time, try saying the commands separately. If the system consistently fails to recognize commands, the voice training procedure should be carried out to improve the recognition response for the speaker. See “Voice Adaptation (VA) mode” in this section.
The system consistently selects the wrong entry from the phone book.	Ensure that the phone book entry name requested matches what was originally stored. This can be confirmed by using the “List Names” command. See “Phonebook” in this section. Replace one of the names being confused with a new name.

Manual control

While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise ...

Bluetooth® Hands-Free Phone System without Navigation System (Type B) (if so equipped)

WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be ...

Other materials:

Fuel pump
Component Function Check 1.CHECK FUEL PUMP FUNCTION Turn ignition switch ON. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES >> INSPECT ...

Component parts
Component Parts Location IPDM E/R, (Headlamp high relay, Headlamp low relay, Taillamp relay and Front fog lamp relay (if equipped)) Stop lamp switch Parking brake switch Combination meter Combination switch (lighting and turn signal switch) BCM (view with combination meter r ...

Wiring diagram
AUTOMATIC AIR CONDITIONING SYSTEM Wiring Diagram ...