Nissan Sentra Service Manual: Daytime light system inoperative
Description
The daytime light system is inoperative even though the combination switch (lighting and turn signal switch) and parking brake switch are in the normal setting, also whenever engine is operating.
Diagnosis procedure
1.Check daytime light operation
- Perform bcm(headlamp) daytime running light active test. Refer to exl-19, "headlamp : consult function (bcm - head lamp)" (with intelligent key system) or exl-22, "headlamp : consult function (bcm - head lamp)" (without intelligent key system).
- Check that the daytime lights turn on.
Is the inspection results normal? Yes >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
No >> go to 2.
2.Check daytime light relay fuse
- Turn ignition switch off.
- Check that the following fuse is not blown.
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 3.
3.Check daytime light bulbs
Check the daytime light bulbs are not open.
Is the inspection result normal? Yes >> go to 4.
No >> replace the bulbs.
4.Perform daytime light circuit inspection
Check the daytime light circuit. Refer to exl-92, "diagnosis procedure".
Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Both side headlamps do not switch
to high beam
Description
The headlamps (both sides) do not switch to high beam when the lighting
switch is in the hi or pass setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switc ...
Both side headlamps (lo) are not
turned on
Description
The headlamps (both sides) do not turn on in any lighting switch setting.
Diagnosis Procedure
1.Check combination switch (lighting and turn signal switch)
Check the combination switc ...
Other materials:
The fuel gauge indicator does not operate
Description
Fuel gauge will not indicate from a certain position.
Diagnosis procedure
1.CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT
Check the fuel level sensor signal circuit. Refer to MWI-58, "Diagnosis
Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> ...
P0607 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0607
ECM
(Control module performance)
ECM internal communication system is malfunctioning.
ECM
DTC CONFIRMATION PROCEDURE
1. ...
General Precautions
Always use a 12 volt battery as power source.
Do not attempt to disconnect battery cables while engine is
running.
Before connecting or disconnecting the ECM harness connector,
turn ignition switch OFF and disconnect negative battery
cable. Failure to do so may damage the ECM because
...
