Description
The headlamps (both sides) do not turn on in any lighting switch setting.
Diagnosis Procedure
1.Check combination switch (lighting and turn signal switch)
Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent Key system) or BCS-125, "Symptom Table" (without Intelligent Key system).
Is the inspection result normal? YES >> GO TO 2
No >> repair or replace the malfunctioning part
2.Check headlamp (lo) request signal input
Consult data monitor

Is the inspection result normal? Yes >> go to 3
No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
3.Headlamp (lo) circuit inspection
Check the headlamp (lo) circuit. Refer to exl-90, "diagnosis procedure".
Is the inspection result normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Daytime light system inoperative
Parking, license plate and tail
lamps are not turned onElectric ignition system
ELECTRIC IGNITION SYSTEM : System Description
SYSTEM DIAGRAM
*1: CVT models
*2: M/T models
Input/output signal chart
Sensor
Input Signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*3
Piston position
Ignition ...
How to Check Terminal
CONNECTOR AND TERMINAL PIN KIT
Use the connector and terminal pin kits listed below when replacing
connectors or terminals.
The connector and terminal pin kits contain some of the most commonly
used NISSAN/INFINITI connectors
and terminals. For detailed connector and terminal pin repla ...
Wiring diagram
Ipdm e/r (intelligent power distribution module engine room)
Wiring diagram
...