Nissan Sentra manuals

Nissan Sentra Service Manual: Both side headlamps do not switch to high beam

Nissan Sentra Service Manual / Driver controls / Exterior lighting system / Symptom diagnosis / Both side headlamps do not switch to high beam

Description

The headlamps (both sides) do not switch to high beam when the lighting switch is in the hi or pass setting.

Diagnosis procedure

1.Combination switch (lighting and turn signal switch) inspection

Check the combination switch (lighting and turn signal switch). Refer to bcs-72, "symptom table" (with intelligent key system) or bcs-125, "symptom table" (without intelligent key system).

Is the inspection results normal? Yes >> go to 2

No >> repair or replace the malfunctioning part.

2.Check headlamp (hi) request signal input

Consult data monitor


  1. Select hl hi req of ipdm e/r data monitor item.
  2. While operating the lighting switch, check the monitor status.

Is the inspection results normal?


Is the inspection results normal? YES >> GO TO 3

NO >> Replace BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key system) or BCS- 126, "Removal and Installation" (without Intelligent Key system).

3.Headlamp (hi) circuit inspection

Check the headlamp (hi) circuit. Refer to exl-88, "diagnosis procedure".

Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).

No >> repair or replace the malfunctioning part.

Exterior lighting system symptoms
Symptom Table Caution: Perform the self-diagnosis with consult before the symptom diagnosis. Perform the trouble diagnosis if any dtc is detected. Normal operating condition Description ...

Daytime light system inoperative
Description The daytime light system is inoperative even though the combination switch (lighting and turn signal switch) and parking brake switch are in the normal setting, also whenever engine is ...

Other materials:

Dlc branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). Is the inspection resul ...

NISSAN Vehicle Immobilizer System keys
You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head. The master key can be used for all the locks. Never leave these keys in the vehicle. Addition ...

Wiring diagram
Brake control system Wiring Diagram ...

В© 2014-2026 Copyright b17.nisentra.com