Description
Fuel gauge will not indicate from a certain position.
Diagnosis procedure
1.CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT
Check the fuel level sensor signal circuit. Refer to MWI-58, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace harness or connector.
2.Component inspection
Perform components inspection for the fuel level sensor unit and combination meter. Refer to mwi-59, "component inspection".
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace malfunctioning parts.
3.Check float interference
Check that the float arm interferes with or binds to other components in the fuel tank.
Is the inspection result normal? Yes >> replace fuel level sensor unit. Refer to fl-6, "removal and installation".
No >> repair or replace malfunctioning parts.
The steering switch (meter control switch) is inoperativeOperating tips
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is
not a malfunction. After the coolant temperature
warms up, air flow from the foot outlets
will operate normally.
...
U1117 Lost communication (ABS)
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
[Trouble diagnosis content]
DTC detection condition
Possible causes
U1117
LOST COMM (ABS)
[Lost Communication With
ABS]
When the ignition switch is ON, TCM is unable
to receive the CAN communications ...
Under cover
Front under cover
Front under cover : removal and installation
REMOVAL
Remove front side of front fender protector (LH/RH). Refer to EXT-28,
"FENDER PROTECTOR : Removal
and Installation - Front Fender Protector".
Remove engine under cover. EXT-31, "ENGINE UNDER COVER : Re ...