Nissan Sentra Service Manual: P0607 ECM
DTC Logic
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition | Possible cause |
| P0607 | ECM (Control module performance) | ECM internal communication system is malfunctioning. | ECM |
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON (engine stopped) and wait least 10 seconds.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Proceed to EC-350, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Erase DTC.
- Perform DTC confirmation procedure. Refer to EC-350, "DTC Logic".
Is the 1st trip DTC P0607 displayed again? YES >> Replace ECM. Refer to EC-485, "Removal and Installation".
NO >> INSPECTION END
P0606 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0606
CONTROL MODULE
(Control module p ...
P060A ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P060A
CONTROL MODULE
(Internal control ...
Other materials:
Body sealing
Description
The following figure shows the areas which are sealed at the factory. Sealant
which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to
apply an excess amount of
sealant and not to allow other unaffected parts to come into conta ...
Wiring diagram
Eco mode system
Wiring Diagram
...
Ecu diagnosis information
Audio unit
Reference value
Terminal layout
Physical values
BluetoothВ® control unit
Reference Value
Terminal layout
Physical values
...
