Nissan Sentra manuals

Nissan Sentra Service Manual: Cluster lid A

Removal and Installation

REMOVAL

  1. Release cluster lid A clips and pawls using a suitable tool.

Metal clip : Pawl


Metal clip



  1. Remove cluster lid A.

INSTALLATION

Installation is in the reverse order of removal.

Center console assembly
Exploded View Center console upper finisher Center console side finisher (RH) Center console side finisher (LH) Center console side finisher screw cover (LH/ RH) Center console asse ...

Cluster lid C
Removal and Installation - Cluster Lid C REMOVAL Remove cluster lid C lower. Refer to IP-20, "Removal and Installation - Cluster Lid C Lower". Remove the cluster lid C screws (A). ...

Other materials:

Symptom diagnosis
Nissan vehicle immobilizer systemnats symptoms Symptom Table Note: Before performing the diagnosis in the following table, check “SEC-171, "Work Flow"”. Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, ...

Unit removal and installation
TRANSMISSION ASSEMBLY Exploded View Transaxle assembly O-ring CVT fluid charging pipe CVT fluid charging pipe cap Tightening must be done following the installation procedure. Refer to TM-283, "Removal and Installation". : Always replace after every disassemb ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

© 2014-2026 Copyright b17.nisentra.com