Nissan Sentra Service Manual: Charging system
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- Dtc/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
Removal and installation
Push-button ignition switch
Removal and installation
Removal
Remove the nats antenna amp. Refer to sec-135, "removal and
installation"
Remove the push-button ignition switch.
I ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE- ...
Other materials:
CVT Oil warmer
Exploded View
Transaxle assembly
O-ring
CVT oil warmer
CVT fluid
Removal and Installation
REMOVAL
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns
could occur from high pressure
coolant escaping from the radiator. Wrap a thick cloth around the cap ...
Warning signals
To help prevent the vehicle from moving unexpectedly
by erroneous operation of the Intelligent
Key or to help prevent the vehicle from being
stolen, a chime or buzzer sounds from inside and
outside the vehicle and a warning light comes on
in the instrument panel.
When a chime or beep sounds ...
On Board Diagnostic (OBD) System of Engine and CVT
The ECM has an on board diagnostic system. It will light up the malfunction
indicator lamp (MIL) to warn the
driver of a malfunction causing emission deterioration.
CAUTION:
Be sure to turn the ignition switch OFF and disconnect the
negative battery cable before any repair
or inspection ...
