Nissan Sentra Service Manual: C1607, C1608 EPS Control unit
DTC Logic
DTC DETECTION LOGIC
| Dtc | Display item | Malfunction detected condition | Possible cause |
| C1607 | EEPROM | When the memory (EEPROM) system malfunction is detected in EPS control unit. | Eps control unit |
| C1608 | CONTROL UNIT | When the internal malfunction is detected in EPS control unit. |
Dtc confirmation procedure
1.Preconditioning
If dtc confirmation procedure has been previously conducted, always turn ignition switch off and wait at least 10 seconds before conducting the next test.
>> Go to 2.
2.DTC REPRODUCTION PROCEDURE
With consult
-
Turn the ignition switch OFF to ON.
-
Perform eps self-diagnosis.
Is dtc c1607 or c1608 detected? Yes >> proceed to diagnosis procedure. Refer to stc-28, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.CHECK TERMINALS AND HARNESS CONNECTORS
Check eps control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace the malfunctioning parts.
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning parts.
2.Perform self-diagnosis
With consult
-
Erase self-diagnostic results for EPS.
-
Turn the ignition switch OFF, and then wait 10 seconds and more.
-
Perform self-diagnosis for EPS.
Is DTC C1607 or C1608 detected? YES >> Replace EPS control unit. Refer to STC-39, "Removal and Installation".
NO >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".
C1606 EPS Motor
DTC Logic
DTC DETECTION LOGIC
Dtc
Display item
Malfunction detected condition
Possible cause
C1606
EPS MOTOR
When the motor driver malfunction of EPS control
unit o ...
C1609 Vehicle speed signal
DTC Logic
Dtc detection logic
DTC
Display item
Malfunction detected condition
Possible cause
C1609
CAN VHCL SPEED
Malfunction is detected in vehicle speed sig ...
Other materials:
Periodic maintenance
Road wheel
Inspection
ALUMINUM WHEEL
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed,
remove wheel and check wheel
runout.
Remove tire from aluminum wheel and mount wheel on a balancer machine.
Set dial indicator as ...
CONSULT Data Link Connector (DLC) Circuit
Inspection procedure
If the CONSULT cannot diagnose the system properly, check the following
items.
Symptom
Check item
CONSULT cannot access any
system.
CONSULT DLC power supply circuit (Terminal 8 and 16) and ground
circuit (Terminal 4 and 5)
...
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other me ...
