Nissan Sentra Service Manual: CONSULT Data Link Connector (DLC) Circuit

Nissan Sentra Service Manual / General information / Basic inspection / Consult checking system / CONSULT Data Link Connector (DLC) Circuit

Inspection procedure

If the CONSULT cannot diagnose the system properly, check the following items.

Symptom	Check item
CONSULT cannot access any system.	CONSULT DLC power supply circuit (Terminal 8 and 16) and ground circuit (Terminal 4 and 5)
CONSULT cannot access individual system. (Other systems can be accessed.)	Power supply and ground circuit for the control unit of the system (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit between the system and CONSULT DLC (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit CAN communication line. Refer to LAN-16, "Trouble Diagnosis Flow Chart".

NOTE:

The DDL2 circuits and CAN communication lines from DLC pins 6, 7 and 14 may be connected to more than one system. A short in a DDL circuit or CAN lines connected to a control unit in one system may affect CONSULT access to other systems. For a complete DDL circuit layout, refer to GI-49, "Wiring Diagram". For a complete CAN line layout, refer to LAN-33, "Wiring Diagram".

Function and System Application

x : Applicable With NAVI With CVT With auto A/C ...

Wiring diagram

Consult checking system Wiring Diagram ...

Other materials:

USB interface (models without Navigation System) (if so equipped)
Connecting a device to the USB input jack WARNINGDo not connect, disconnect, or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury. CAUTION Do not force t ...

Front drive shaft boot
Exploded View (LH) Circular clip Dust shield Slide joint housing Snap ring Spider assembly Boot band Boot Shaft Damper band Dynamic damper Circular clip Joint sub-assembly Wheel side (RH) 6M/T Joint sub-assembly Circular clip Boot band Boot Shaft Dam ...

Precaution for Work
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a ...