Nissan Sentra manuals

Nissan Sentra Service Manual: Dlc branch line circuit

Diagnosis procedure

1.Check connector

  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

Check the resistance between the data link connector terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? Yes (present error)>>check can system type decision again.

Yes (past error)>>error was detected in the data link connector branch line circuit.

No >> repair the data link connector branch line.

A-bag branch line circuit
Diagnosis procedure Warning: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch off, disconnect battery negative terminal, and w ...

Eps branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for dam ...

Other materials:

Moonroof switch
Removal and installation REMOVAL Remove the map lamp. Refer to INL-52, "Removal and Installation". Release the pawls and remove the moonroof switch finisher (1). : Pawl Release the pawls and remove the moonroof switch (2). : Pawl INSTALLATION Installation is in the ...

Dtc/circuit diagnosis
U1000 can comm circuit DTC Logic Dtc detection logic Consult display Dtc detection condition Possible cause Can comm circuit [u1000] Av control unit is not transmitting or receiving can communication signal for 2 seconds or more. CAN communication system. ...

NISSAN vehicle immobilizer system (if so equipped)
The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on ...

В© 2014-2026 Copyright b17.nisentra.com