Nissan Sentra manuals

Nissan Sentra Service Manual: Body component parts


  1. Moonroof panel assembly
  2. Roof panel assembly
  3. Front roof rail
  4. Roof rail
  5. Rear roof rail
  6. Moonroof frame assembly
  7. Hood assembly
  8. Front fender (RH, LH)
  9. Outer front door panel (RH, LH)
  10. Outer rear door panel (RH, LH)
  11. Front door assembly (RH, LH)
  12. Rear door assembly (RH, LH)
  13. Front body side outer (RH, LH)
  14. Rear body side outer (RH, LH)
  15. Rear wheel housing outer (RH, LH)
  16. Rear pillar reinforcement (RH, LH)
  17. Outer sill reinforcement (RH, LH)
  18. Front pillar reinforcement (RH, LH)
  19. Front pillar reinforcement (RH, LH)
  20. Center pillar reinforcement (RH, LH)
  21. Roof side rail reinforcement (RH, LH)
  22. Center pillar inner (RH, LH)
  23. Roof inner side rail (RH, LH)
  24. Rear wheel housing inner (RH, LH)
  25. Rear inner sill extension (RH, LH)
  26. Rear panel assembly (RH, LH)
  27. Rear parcel shelf extension (RH, LH)
  28. Rear panel
  29. Trunk lid assembly

Removal and installation Front


Repairing material
Foam Repair During factory assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam i ...

Removal and installation
...

Other materials:

Garage Jack and Safety Stand and 2-Pole Lift
WARNING: Park the vehicle on a level surface when using the jack. Make sure to avoid damaging pipes, tubes, etc. under the vehicle. Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle. Place wheel chock ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...

Diagnosis system (bcm) (without intelligent key system)
Common item Common item : consult function (bcm - common item) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Description ECU identification The BCM part number is displayed. Self Diagnostic Result ...

В© 2014-2026 Copyright b17.nisentra.com