Nissan Sentra Service Manual: B2267 engine speed
Description
The engine speed signal is transmitted from ecm to the combination meter via can communication.
Dtc logic
Dtc detection logic
| Dtc | Consult | Detection condition | Possible malfunction location |
| B2267 | Tacho meter [b2267] | ECM continuously transmits abnormal engine speed signals for 2 seconds or more |
|
Diagnosis procedure
1.Perform self-diagnosis of ecm
Perform self diagnostic result of ecm, and repair or replace malfunctioning parts.
>> Refer to ec-66, "consult function".
B2205 vehicle speed
Description
The abs actuator and electric unit (control unit) provides a vehicle speed
signal to the combination meter via
can communication lines.
DTC Logic
Dtc detection logic
Dtc
...
B2268 water temp
Description
The engine coolant temperature signal is transmitted from ecm to the
combination meter via can communication.
Dtc logic
Dtc detection logic
Dtc
Consult
Detection condit ...
Other materials:
Bcm branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES > ...
Parking/parking on hills
WARNING
Do not stop or park the vehicle over
flammable materials such as dry grass,
waste paper or rags. They may ignite
and cause a fire.
Safe parking procedures require that
both the parking brake be set and the
transmission placed into P (Park) for
CVT m ...
Front disc brake
Brake Burnishing
CAUTION:
Burnish contact surfaces between brake pads and disc rotor
according to the following procedure
after refinishing the disc rotor, replacing brake pads or if a soft pedal
occurs at very low mileage.
Be careful of vehicle speed. Brakes do not operate firmly/sec ...
