Nissan Sentra Service Manual: ASCD Indicator

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / ASCD Indicator

Component Function Check

1.CHECK ASCD INDICATOR FUNCTION

Check ASCD indicator under the following conditions.

ASCD INDICATOR	CONDITION		SPECIFICATION
CRUISE LAMP	Ignition switch: ON	MAIN switch: Pressed at the 1st time → at the 2nd time	ON → OFF
SET LAMP	MAIN switch: ON When vehicle speed is between 38 km/h (24 MPH) and 160 km/h (100 MPH)	ASCD: Operating	ON
SET LAMP		ASCD: Not operating	OFF

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-449, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform trouble diagnosis for DTC UXXXX.

2.CHECK DTC WITH COMBINATION METER

Check DTC with combination meter. Refer to MWI-26, "DTC Index".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Repair or replace error-detected parts.

Brake pedal position switch

Component Function Check 1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT Turn ignition switch ON. Select вЂњENGINEвЂќ using CONSULT. Select вЂњBRAKE SW1вЂќ in вЂњDA ...

Fuel injector

Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Proceed to EC-450, "Diagnosis Procedure". 2.CH ...

Other materials:

P0524 Engine oil pressure
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0524 ENGINE OIL PRESSURE (Engine oil pressure too low) An EOP sensor signal voltage applied to ECM remains lower than the specified ...

Basic inspection
Diagnosis and repair workflow Workflow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.SYMPTOM CHECK Verify symptoms. ...

Blower motor
Exploded View Heating and cooling unit assembly Blower motor Front Removal and Installation Remove the glove box assembly. Refer to IP-22, "Removal and Installation". Disconnect the harness connector from the blower motor. Remove the blower motor screws. Remove ...