Nissan Sentra Service Manual: Removal and installation
Ipdm e/r
Exploded view
- Ipdm e/r
- IPDM E/R cover A
- Ipdm e/r cover b
Removal and installation
Caution:
Ipdm e/r integrated relays are not serviceable and must not be removed from unit.
Removal
- Remove inlet air duct (upper). Refer to em-25, "removal and installation".
- Remove battery. Refer to pg-50, "removal and installation (battery)".
- Release pawls (a) on ipdm e/r cover and remove ipdm e/r (1) from ipdm e/r cover b (2).
- Disconnect harness connector and then remove ipdm e/r.
- Remove engine room harness from ipdm e/r cover b.
- Remove ipdm e/r cover b nuts (a).
- Insert a suitable tool (a) between ipdm e/r cover a (1) and ipdm e/r cover b (2), disengage pawls, and remove ipdm e/r cover a.
- Remove ipdm e/r cover b.
Installation
Installation is in the reverse order of removal.
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
Dtc detection logic
Consult display
Dtc detection condition
P ...
Other materials:
Transverse link
Exploded View
Upper link
Front suspension member
Transverse link
Front
Removal and Installation
REMOVAL
Remove the wheel and tire using power tool. Refer to WT-47, "Exploded
View".
Remove the nut and bolt from the lower ball joint. Disconnect the
transverse l ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
Harness connector e4
Harness connec ...
C1708, C1709, C1710, C1711 Transmitter (no data)
DTC Logic
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Registe ...
