Nissan Sentra Service Manual: The key warning does not sound (without intelligent key)

Nissan Sentra Service Manual / Driver information & multimedia / Warning chime system / Symptom diagnosis / The key warning does not sound (without intelligent key)

Description

The key warning chime does not sound, when all of the following conditions are fulfilled.

Key inserted into the key cylinder (key switch signal on).
Ignition switch is in acc or off (ignition switch signal off).
Driver side door is open (driver side door switch on)

Diagnosis procedure

1.Check bcm input signal

Connect CONSULT
Select the data monitor of bcm (buzzer) and check the key on sw monitor value. Refer to bcs- 88, "buzzer : consult function (bcm - buzzer)".

Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).

No >> go to 2.

2.Check key switch signal circuit

Check the key switch signal circuit. Refer to dlk-262, "diagnosis procedure".

No >> check applicable parts, and repair or replace corresponding parts.

The light reminder warning does not sound

Description Light reminder warning chime does not sound even though headlamp is illuminated. Diagnosis procedure 1.Check combination meter input signal Select the data monitor for the meter/m&am ...

Audio, visual & navigation system

...

Other materials:

Basic inspection
Diagnosis and repair workflow Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM ...

Sensor rotor
Front sensor rotor FRONT SENSOR ROTOR : Removal and Installation The front wheel sensor rotor is an integral part of the wheel hub and bearing assembly and cannot be disassembled. Refer to FAX-8, "Removal and Installation". Rear sensor rotor REAR SENSOR ROTOR : Removal and Install ...

P1574 ASCD Vehicle speed sensor
Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-51, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...