Nissan Sentra Owners Manual: Parking brake

Nissan Sentra Owners Manual / Starting and driving / Parking brake

WARNING

Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident.
Do not release the parking brake from outside the vehicle.
Do not use the shift lever in place of the parking brake. When parking, be sure the parking brake is fully engaged.
Do not leave children unattended in a vehicle. They could release the parking brake and cause an accident.

To engage: Pull the lever up A .

To release:

Firmly apply the foot brake.
Manual transmission models:

Place the shift lever in the N (Neutral) position.

CVT models: Move the shift lever to the P (Park) position.

While pulling up on the parking brake lever slightly, push the button and lower completely B .
Before driving, be sure the brake warning light goes out.

Manual transmission (if so equipped)

WARNING Do not downshift abruptly on slippery roads. This may cause a loss of control. Do not over-rev the engine when shifting to a lower gear. This may cause a loss of con ...

SPORT mode switch

Adjusts the throttle sensitivity and transmission points (CVT only) to enhance performance. Press the SPORT button on the instrument panel to activate. The SPORT mode indicator light (on the s ...

Other materials:

Basic inspection
Diagnosis and repair work flow Work flow Overall sequence Detailed flow 1.Get information for symptom Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the вЂњdiagnostic work sheetвЂќ. ( ...

U0155 Lost communication (IPC)
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms [Trouble diagnosis content] DTC detection condition Possible causes U0155 LOST COMM (IPC) [Lost Communication With Instrument Panel Cluster (IPC) Control Module] When the ignition switch is ON, TCM is ...

Ipdm-e branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ipdm e/r for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes ...