Nissan Sentra Service Manual: The ambient temperature display is incorrect
Description
- The displayed outside air temperature is higher than the actual temperature.
- The displayed outside air temperature is lower than the actual temperature.
- Outside air temperature is not indicated.
Diagnosis procedure
1.Check ambient sensor signal circuit
Check the ambient sensor signal circuit. Refer to hac-63, "diagnosis procedure" (with auto a/c) or mwi-62, "diagnosis procedure" (without auto a/c).
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check ambient sensor
Check the ambient sensor. Refer to mwi-62, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> replace ambient sensor. Refer to hac-106, "removal and installation".
The parking brake release warning continues displaying, or does not display
Description
The parking brake warning is displayed while driving the vehicle even
though the parking brake is released.
The parking brake warning is not displayed while driving the vehicle
...
The low washer fluid warning lamp does not turn on or off
Description
The low washer fluid warning lamp is still illuminated even after washer
fluid is added.
The low washer fluid warning lamp is not illuminated even though the
washer tank is emp ...
Other materials:
Diagnosis system (bcm) (with intelligent key system)
Common item
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
ECU identification
The BCM part number is displayed.
Self Diagnostic Result
...
Front seat
Driver side
DRIVER SIDE : Exploded View
Driver side
Headrest
Headrest holder (locked)
Headrest holder (free)
Seatback silencer
Seatback trim
Seatback pad
Seat belt buckle
Seat cushion outer finisher (RH)
Slide cover (RH)
Seat cushion inner finisher (RH)
Recline mech ...
Eps branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the eps control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
