WARNING
|
NOTE:
This feature is automatically disabled if the connected device does not support the Message Access Profile (MAP). See the phone’s Owner’s Manual for details and instructions.
The system allows for the sending and receiving of text messages through the vehicle interface.
Sending a text message:
button.For more information about these options, see “Voice commands” in this section.
To send one of the custom messages, say “Custom Message”. If more than one custom message is stored, the system will prompt for the number of the desired custom message. For more information on setting and managing custom text messages, see “Bluetooth® settings” in this section.
Reading a received text message:
button.The text message, sender and delivery time are
shown on the screen. Use the tuning switch on
the steering wheel to scroll through all text messages
if more than one are available. Press
the
button to exit the text message
screen.
Press the
button to access the
following
options for replying to the text message:
Speak this command to call the sender of the text message using the Bluetooth® Hands-Free Phone System.
Speak this command to send a text message response to the sender of the text message.
Speak this command to read the text message again.
Speak this command to move to the previous text message (if available).
Speak this command to move to the next text message (if available).
NOTE:
Text messages are only displayed if the vehicle speed is less than 5 mph (8 km/h).
During a call
Bluetooth® settingsWiring diagram
Sport mode system
Wiring diagram
...
P1574 ASCD Vehicle speed sensor
Description
The ECM receives two vehicle speed sensor signals via CAN communication line.
One is sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD
control. Refer to EC-51, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...
Moonroof unit assembly
Inspection
WIND DEFLECTOR
Open glass lid fully
Visually check for proper installation, damaged/deteriorated components,
or foreign objects within mechanism.
Correct as required for smooth operation.
Check for grease at the wind deflector arm (1) and pivot areas. If
necessary, apply ...