Nissan Sentra Service Manual: Steering column covers
Removal and Installation
REMOVAL
- Remove the steering column cover screws (A), then remove the steering column upper (1) and lower (2) covers.
NOTE:
- Shown with steering wheel removed for clarity.
- If necessary, rotate steering wheel to access steering column cover screws (A).
INSTALLATION
Installation is in the reverse order of removal.
Instrument panel assembly
Exploded View
Instrument panel assembly
Ambient sensor
Defroster grille (RH)
Defroster grille (LH)
Sunload sensor (if equipped)
Side defroster grille (LH)
Instrument side finisher ...
Center console assembly
Exploded View
Center console upper finisher
Center console side finisher (RH)
Center console side finisher (LH)
Center console side finisher screw cover (LH/
RH)
Center console asse ...
Other materials:
P1652 Starter motor system comm
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
Removal and installation
A/C SWITCH ASSEMBLY
Removal and Installation
REMOVAL
Remove the CVT shift selector finisher (CVT: RE0F11A). Refer to TM-253,
"Removal and Installation".
Remove the MT shift selector finisher (6MT: RS6F94R). Refer to TM-22,
"Removal and Installation".
Remove the A/ ...
Checking engine oil level
Park the vehicle on a level surface and apply
the parking brake.
Start the engine and let it idle until it reaches
operating temperature.
Turn off the engine. Wait more than
10 minutes for the oil to drain back into
the oil pan.
Remove the dipstick and wipe it clean. Reinsert
...
