Nissan Sentra Service Manual: High-mounted stop lamp
Removal and Installation
HIGH-MOUNTED STOP LAMP - WITH REAR SPOILER
Removal
- Remove the rear air spoiler. Refer to EXT-46, "Removal and Installation".
- Remove the screws and the high-mount stop lamp from the rear air spoiler.
Installation
Installation is in the reverse order of removal.
HIGH-MOUNTED STOP LAMP - WITHOUT REAR SPOILER
Removal
- Slide high-mounted stop lamp (1) rearward on parcel shelf to provide clearance for front tabs (A).
- Lift front of lamp assembly up and pull forward to provide clearance for rear tabs (B).
- Disconnect the harness connector from the high-mounted stop lamp and remove.
Installation
Installation is in the reverse order of removal.
Bulb Replacement
HIGH-MOUNTED STOP LAMP - WITH REAR SPOILER
The high-mounted stop lamp LED bulb is integrated into the high-mounted stop lamp and is serviced as an assembly. Refer to EXL-124, "Removal and Installation".
HIGH-MOUNTED STOP LAMP - WITHOUT REAR SPOILER
The high-mounted stop lamp LED bulb is integrated into the high-mounted stop lamp and is serviced as an assembly. Refer to EXL-124, "Removal and Installation".
Door mirror turn signal lamp
Removal and installation
The door mirror side turn signal lamp is integrated into the door mirror
assembly and is serviced as an assembly.
Refer to MIR-18, "Exploded View". ...
License plate lamp
Removal and Installation
REMOVAL
Remove the license lamp finisher. Refer to EXT-44, "Removal and
Installation".
Disconnect the harness connector (A) from the license plate
lamp ( ...
Other materials:
C1601 Battery power supply
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1601
BATTERY VOLT
When a power supply voltage to the EPS control unit
is maintained at 17.5 V or more or at less than 9 V
continuously for five second or more.
...
Anti-pinch inspection
Description
If any of the following operations are performed, the initialization is
necessary for normal operation of antipinch
function.
Disconnection and connection of battery cable from negative terminal.
When power window main switch replaced.
Electric power supply to power window ma ...
P0137 HO2S2
DTC Logic
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time
between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen
storage capacity of the three way catalyst (manifold) causes the
longer switching time. To judge the malfunctions of heated oxygen
...
