Nissan Sentra Service Manual: Removal and installation
Eco mode switch
Removal and Installation
Removal
- Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
- Remove eco mode switch.
Installation
Installation is in the reverse order of removal.
Dtc/circuit diagnosis
Eco mode switch
Component function check
1. Check eco mode switch operation
Turn ignition switch on.
Check ECO mode indicator lamp turns ON/OFF on combination meter when
turn ECO mode switc ...
Eco mode (cvt)
...
Other materials:
Front drive shaft boot
Exploded View
(LH)
Circular clip
Dust shield
Slide joint housing
Snap ring
Spider assembly
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Wheel side
(RH) 6M/T
Joint sub-assembly
Circular clip
Boot band
Boot
Shaft
Dam ...
Emission control system warranty
Your NISSAN vehicle is covered by the following
emission warranties:
For USA
Emission Defects Warranty
Emissions Performance Warranty
Details of this warranty may be found with other
vehicle warranties in your Warranty Information
Booklet which comes with your NISSAN vehicle.
If you ...
Wiring diagram
Ipdm e/r (intelligent power distribution module engine room)
Wiring diagram
...
